ACS services and server configuration

Enable ACS services

To enable ACS in Splynx, navigate to Config → Integrations and find Main modules button:

main modules

and enable a toggle for TR-069 (ACS):

enable

Once TR-069 (ACS) is enabled you will see a new sector under left side menu under Networkingsection:

menu

ACS server configuration

Let's start configuring the ACS server:

Step 1

Navigate to Config → Networking → TR-069 (ACS) and click on install the ACS server:

install

Once it was installed specify its global parameters:

global config

Here we have the next options:

  • Enable ACS services - enable/disable ACS servicesn such as genieacs-cwmp, genieacs-nbi, genieacs-fs. Can be used to reboot the ACS server;

  • SSL enabled by default - enable/disable using of domain name except of IP for access. Can be enabled only if HTTPS/SSL is configured under Config → Main → HTTPS/SSL;

  • Allowed networks - list of allowed networks for connecting to cwmp service. To allow all host use all value;

  • Username - using for authorization to connect to cwmp service. ATTENTION!: authorization is possible only if username and password fields are not empty;

  • Password - using for authorization to connect to cwmp service. ATTENTION!: authorization is possible only if username and password fields are not empty;

  • Hostname - hostname without protocol and port (192.168.105.80 or mysplynx.com depending on your configuration);

  • Periodic inform inverval (seconds) - interval on how often Splynx will sync with an ACS.

Don't forget to click on Save button when configuration is completed.

Step 2

On the same menu Config → Networking → TR-069 (ACS) let's configure ACS User Interface parameters:

config_ui

  • Enable ACS UI - enable/disable an access via web interface;

  • Allowed networks - specify allowed networks from which you can access to the ACS UI. To allow all hosts, please add the all value;

  • UI username - username for UI access. ATTENTION!: authorization is possible only if username and password fields are not empty;

  • UI password - password for UI access. ATTENTION!: authorization is possible only if username and password fields are not empty.

Don't forget to click on Save button when configuration is completed.

Step 3

Click on a link for UI here:

UI link

And you should be redirected to the Genie ACS page, if you prompted for login/password use the credentials from a step 2.

After successful login you will see a window as in the screenshot below, you should click on "ABRACADABRA" button.

abracadabra

The default username and password for GenieACS are: admin / admin

Once this done, you will see GenieACS dashboard:

genie