ACS services and server configuration
Enable ACS services
To enable ACS in Splynx, navigate to Config → Integrations
and find Main modules button:
and enable a toggle for TR-069 (ACS):
Once TR-069 (ACS) is enabled you will see a new sector under left side menu under Networking
section:
ACS server configuration
Let's start configuring the ACS server:
Step 1
Navigate to Config → Networking → TR-069 (ACS)
and click on install the ACS server:
Once it was installed specify its global parameters:
Here we have the next options:
-
Enable ACS services - enable/disable ACS servicesn such as genieacs-cwmp, genieacs-nbi, genieacs-fs. Can be used to reboot the ACS server;
-
SSL enabled by default - enable/disable using of domain name except of IP for access. Can be enabled only if HTTPS/SSL is configured under
Config → Main → HTTPS/SSL
; -
Allowed networks - list of allowed networks for connecting to cwmp service. To allow all host use
all
value; -
Username - using for authorization to connect to cwmp service. ATTENTION!: authorization is possible only if username and password fields are not empty;
-
Password - using for authorization to connect to cwmp service. ATTENTION!: authorization is possible only if username and password fields are not empty;
-
Hostname - hostname without protocol and port (192.168.105.80 or mysplynx.com depending on your configuration);
-
Periodic inform inverval (seconds) - interval on how often Splynx will sync with an ACS.
Don't forget to click on Save button when configuration is completed.
Step 2
On the same menu Config → Networking → TR-069 (ACS)
let's configure ACS User Interface parameters:
-
Enable ACS UI - enable/disable an access via web interface;
-
Allowed networks - specify allowed networks from which you can access to the ACS UI. To allow all hosts, please add the
all
value; -
UI username - username for UI access. ATTENTION!: authorization is possible only if username and password fields are not empty;
-
UI password - password for UI access. ATTENTION!: authorization is possible only if username and password fields are not empty.
Don't forget to click on Save button when configuration is completed.
Step 3
Click on a link for UI here:
And you should be redirected to the Genie ACS page, if you prompted for login/password use the credentials from a step 2.
After successful login you will see a window as in the screenshot below, you should click on "ABRACADABRA" button.
IMPORTANT: All check-boxes should be selected.
The default username and password for GenieACS are: admin
/ admin
Once this done, you will see GenieACS dashboard: