CPE (Customer Premises Equipment) configuration

To configure features of CPE navigate to Config → Networking → CPE:

The following parameters can be configured here:

Size

• 1KB is - specify the amount of bytes for 1KB for CPE traffic accounting(1000 or 1024 bytes).

API

• Debug - enables mikrotik debug log(for debug/test purposes);

• Attempts - select the connection attempts(1-10);

• Timeout - select timeout in seconds.

QoS

• Reverse in/out - enable this if you want to change upload by download and vice versa;

• Queue type for download - Set the queue download type;

• Queue type for upload - Set the queue upload type.

• Default QoS rules - QoS rules can be specified here in format 1 rule = 1 line;

• Simple target (default) - select a network.

WLAN

• Enable WLAN management - enables/disables WLAN management.

Customer blocking

• Enable blocking on CPE - enables/disablse blocking on CPE with NAT rules;

• IP - specify the IP to send all traffic to;

• Port - specify the port to send all traffic to.

DHCP (default configuration)

• Enable - enables/disables using of the default config on the CPE;

• Name - specify a name of the DHCP server;

• Interface - type of interface;

• Lease time - lease time in minutes;

• Network - specify the network;

• Gateway - specify the gateway;

• Pool from - use IPs start from this IP;

• Pool to - last IP to be used from pool;

• DNS servers - specify DNS servers separated by comma;

• WINS servers - specify WINS servers separated by comma.

And don't forget to save settings after change.